Parameters 

Description 

Sensor sens 

the Sensor object to be updated  

Double heartBeat 

How often the sensor communicates with the gateway if no activity recorded.  

Double awareStateHeartBeat 

How often the sensor communicates with the gateway while in Aware State.  

Integer overflowCount 

While not in the aware state, counts above this value cause the sensor to go into the aware state and transmit immediately.  

Integer awareStateOverflowCount 

While in the aware state, counts below this value transition the sensor from aware state to not aware.  

Boolean accumulate 

Standard operation reports the number of pulses detected between heartbeats. Accumulate on will accumulate the readings heartbeat after heartbeat. accumulation rolls over at 65535.  

Integer pulseEdgeDetection 

determines whether pulses are recorded at the positive edge of the pulse or the negative edge of the pulse. Positive edge = 0, Negative Edge = 1, or both edges = 2  

Integer filter 

Determines if there is a filter and at what Hz the filter is set to. 40 Hz Filter = 0, 4 Hz Filter = 1, or No Filter = 2.  

Integer failedTransmissionsBeforeLinkMode 

The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.)