Parameters 

Description 

Sensor sens 

the Sensor object to be updated  

Double heartBeat 

How often the sensor communicates with the gateway if no activity recorded.  

Double awareStateHeartBeat 

How often the sensor communicates with the gateway while in Aware State.  

Integer assessmentsPerHeartbeat 

How many times between heartbeats a sensor will check its measurements against its thresholds to determine whether it will enter the Aware State.  

Double minimumThreshold 

Any assessments below this Celsius value will cause the sensor to enter the Aware State.  

Double maximumThreshold 

Any assessments above this Celsius value will cause the sensor to enter the Aware State.  

Double Hysteresis 

A buffer to prevent the sensor from bouncing between Standard Operation and Aware State when the assessments are very close to a threshold. For example, if a Maximum threshold is set to 90 degrees Celsius and a Hysteresis of 1 degree, then once the sensor takes an assessment of 90 degrees and enters the Aware State it will remain in the Aware state until the temperature readings drop to 89 degrees similarly, at the minimum threshold the temperature will have to rise a degree above the threshold to return to Standard Operation.  

Long deltaLightReport 

 

Integer threshSelector 

 

Integer Offset 

 

Integer failedTransmissionsBeforeLinkMode 

The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.)  

Integer powerOptions 

None = 0, Digital High = 1, Digital Low = 2, Amplifier SP9 Active Low = 3. Default value is 0  

Integer delayInMilliseconds 

The Amount of Time delayed