Allows for the update of the specific type of sensor. @param sens the Sensor object to be updated @param heartBeat How often the sensor communicates with the gateway if no activity recorded. @param awareStateHeartBeat How often the sensor communicates with the gateway while in Aware State. @param Phase123MinThreshold Values above Phase123MaxThreshold or below Phase123MinThreshold will cause the sensor to go aware @param Phase123MaxThreshold Values above Phase123MaxThreshold or below Phase123MinThreshold will cause the sensor to go aware @param Phase123Hysteresis When going from aware to non aware regions the sensor must go into the the non aware region by Threshmin + Hysteresiss or Threshmax - Hysteresis in order to become non aware. This prevents rapid reporting of data when the sensor is reading at or near a threshold. @param Phase123Duty Values above this threshold will contribute to the average current/power. Ex: If the value is set to 10 amps or Watts and the current is below 10 amps or watts the entire heartbeat the average current or power will indicate 0 If above this @param MeasurementInterval Interval between measurements @param accumulate If set to accumulate the total power accumulation will add to the previous accumulation. If not set, total power accumulation will reset to 0 immediately after reporting. @param failedTransmissionsBeforeLinkMode The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.)

ThreePhase20AmpMeterBase Methods