Allows for the update of the specific type of sensor. @param sens the Sensor object to be updated @param heartBeat How often the sensor communicates with the gateway if no activity recorded. @param awareStateHeartBeat How often the sensor communicates with the gateway while in Aware State. @param minimumPitchThreshold Any Pitch below this threshold will put the sensor in the Aware State. @param maximumPitchThreshold Any Pitch above this threshold will put the sensor in the Aware State. @param measurementStability Number of measurements after a movement into a valid UP or DOWN region to wait until reporting the current pitch and status. @param stuckTimeOut Number of seconds after movement out of a valid UP or DOWN region to wait until reporting stuck. @param axisMode Rotational Axis that the sensor will tilt around. (0 is +X, 1 is -X, 2 is +Y, 3 is -Y, 4 is +Z, 5 is -Z) (ONLY ENABLED FOR ALTA MODE) @param dataMode Select 1= Up/Down vs 0 = Delta MODE @param awareMode 0= None/ 1 = On Change(Delta Exceeded)/2 = Not Down/ 3 = Not Up / 4= Stuck [Delta Mode only shows options 0 and 1] @param rearmTime After the sensor triggers due to the delta value being exceeded, it must wait this long before it can trigger again @param failedTransmissionsBeforeLinkMode The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.)

TriggeredTiltBase Methods