Allows for the update of the specific type of sensor. @param sens the Sensor object to be updated @param heartBeat How often the sensor communicates with the gateway if no activity recorded. @param pollInterval The frequency that this unit polls the gateway to ask if there are controll messages waiting to be acted on. @param defaultStateRelay1 the default state is the state the relay is in on power up. and also the state that the relay is in while the paired sensor is in the standard opperating state'. if a sensor is paired and the sensor enters the aware mode the relay will toggle to the non default state. @param pairedSensorIDRelay1 Sensor ID of sensor that will toggle relay 1 to non default state when sensor is in aware state. @param defaultStateRelay2 the default state is the state the relay is in on power up. and also the state that the relay is in while the paired sensor is in the standard opperating state'. if a sensor is paired and the sensor enters the aware mode the relay will toggle to the non default state. @param pairedSensorIDRelay2 Sensor ID of sensor that will toggle relay 2 to non default state when sensor is in aware state. @param failedTransmissionsBeforeLinkMode The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.)

Control_1Base Methods