Java Mine
ContentsIndexHome
PreviousUpNext
TriggeredTiltBase.SensorEdit Method
Syntax
Java
public static void SensorEdit(Sensor sens, Double heartBeat, Double minimumPitchThreshold, Double maximumPitchThreshold, Integer measurementStability, Integer stuckTimeOut, Integer axisMode, Integer dataMode, Integer awareMode, Integer rearmTime, Double deltaValue, Integer failedTransmissionsBeforeLinkMode);

 

Allows for the update of the specific type of sensor. @param sens the Sensor object to be updated @param heartBeat How often the sensor communicates with the gateway if no activity recorded. @param awareStateHeartBeat How often the sensor communicates with the gateway while in Aware State. @param minimumPitchThreshold Any Pitch below this threshold will put the sensor in the Aware State. @param maximumPitchThreshold Any Pitch above this threshold will put the sensor in the Aware State. @param measurementStability Number of measurements after a movement into a valid UP or DOWN region to wait until reporting the current pitch and status. @param stuckTimeOut Number of seconds after movement out of a valid UP or DOWN region to wait until reporting stuck. @param axisMode Rotational Axis that the sensor will tilt around. (0 is +X, 1 is -X, 2 is +Y, 3 is -Y, 4 is +Z, 5 is -Z) (ONLY ENABLED FOR ALTA MODE) @param dataMode Select 1= Up/Down vs 0 = Delta MODE @param awareMode 0= None/ 1 = On Change(Delta Exceeded)/2 = Not Down/ 3 = Not Up / 4= Stuck [Delta Mode only shows options 0 and 1] @param rearmTime After the sensor triggers due to the delta value being exceeded, it must wait this long before it can trigger again @param failedTransmissionsBeforeLinkMode The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.)

Copyright (c) 2023. All rights reserved.
What do you think about this topic? Send feedback!