Name 

Description 

 

ActionControlCommandIsUrgent 

The action control command that will be sent to the sensor is urgent  

 

ActionControlCommands 

The action control command(s) that will be sent to the sensor  

 

ActiveStateInterval 

Defines in minutes the interval at which the sensor communicates with the gateway when the sensor is in the aware state. Unless triggered to communicate earlier, the sensor will send a data message to the gateway when this many minutes elapse.  

 

FirmwareVersion 

Tracks the version of firmware. Some features are only available on certain firmware versions.  

 

GeneralConfig1Dirty 

If set this flag will cause the General Config 1 page to be sent to the sensor Affected Fields: Report Interval, ActiveStateInterval, TransmitIntervalLink  

 

GeneralConfig2Dirty 

If set this flag will cause the General Config 2 page to be sent to the sensor Affected Fields: Recovery, RetryCount  

 

MinimumThreshold 

For interval based sensors (Temperature, Humidity, etc) If reading is below this value the sensor enters aware mode  

 

MonnitApplication 

Identifier of the sensor application type. (Temp/Humidity/etc)  

 

PendingActionControlCommand 

If set this flag will cause the action control command will be sent to the sensor  

 

ProfileConfig1Dirty 

If set this flag will cause the Profile Config 1 page to be sent to the sensor Affected Fields (Interval): MeasurementsPerTransmission, MaximumThreshold, MinimumThreshold, Hysteresis Affected Fields (Trigger): EventDetectionCount, EventDetectionPeriod, EventDetectionType, BiStable, RearmTime  

 

ProfileConfig2Dirty 

If set this flag will cause the Profile Config 2 page to be sent to the sensor Affected Fields (Interval): Calibration1, Calibration2, Calibration3, Calibration4  

 

Recovery 

Defines the number of failed transmission sets before entering link mode  

 

ReportInterval 

Defines in minutes the interval at which the sensor communicates with the gateway. Unless triggered to communicate earlier, the sensor will send a data message to the gateway when this many minutes elapse.  

 

RetryCount 

Defines the number of back to back attempts in a transmission set  

 

SensorID 

Unique numeric identifier of the sensor.  

 

TransmitIntervalLink 

Sets the time between link attempts in link mode. Default: 2