Parameters 

Description 

ISensor sens 

sens the Sensor object to be updated  

double? heartBeat 

How often the sensor communicates with the gateway if no activity recorded. 

double? awareStateHeartBeat 

How often the sensor communicates with the gateway while in Aware State. 

int? failedTransmissionsBeforeLinkMode 

The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.) 

minimumPitchThreshold 

Any Pitch below this threshold will put the sensor in the Aware State. 

maximumPitchThreshold 

Any Pitch above this threshold will put the sensor in the Aware State. 

minimumRollThreshold 

Any Roll below this threshold will put the sensor in the Aware State. 

maximumRollThreshold 

Any Roll above this threshold will put the sensor in the Aware State. 

AwareStateBuffer 

A buffer to prevent the sensor from bouncing between Standard Operation and Aware State when the assessments are very close to a threshold. For example, if a Maximum threshold is set to 90 degrees and a Hysteresis of 1 degree, then once the sensor takes an assessment of 90 degrees and enters the Aware State it will remain in the Aware state until the temperature readings drop to 89 degrees similarly, at the minimum threshold the temperature will have to rise a degree above the threshold to return to Standard Operation.