Parameters 

Description 

ISensor sens 

sens the Sensor object to be updated sensor to enter the Aware State. 

double? heartBeat 

How often the sensor communicates with the gateway if no activity recorded. 

Boolean? accumulate 

Standard operation reports the number of pulses detected between heartbeats. Accumulate on will accumulate the readings heartbeat after heartbeat. accumulation rolls over at 65535. 

int? pulseEdgeDetection 

determines whether pulses are recorded at the positive edge of the pulse or the negative edge of the pulse. Positive edge = 0, Negative Edge = 1, or both edges = 2 

int? stabilizationDelay 

Milliseconds to wait for confirming positive reading after pulse initially detected.(Debouncing) Recommended 50% of minimum pulse width of input signal. 

int? failedTransmissionsBeforeLinkMode 

The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.) 

maximumthreshold 

Any assessments above this value will cause the