C# Mine
|
Allows for the update of the specific type of sensor.
Parameters |
Description |
ISensor sens |
sens the Sensor object to be updated |
double? heartBeat |
How often the sensor communicates with the gateway if no activity recorded. |
double? awareStateHeartBeat |
How often the sensor communicates with the gateway while in Aware State. |
int? V123Hyst |
When going from aware to non aware regions the sensor must go into the the non aware region by Threshmin + Hysteresiss or Threshmax - Hysteresis in order to become non aware. This prevents rapid reporting of data when the sensor is reading at or near a threshold. |
int? I1Hyst |
When going from aware to non aware regions the sensor must go into the the non aware region by Threshmin + Hysteresiss or Threshmax - Hysteresis in order to become non aware. This prevents rapid reporting of data when the sensor is reading at or near a threshold. |
int? I2Hyst |
When going from aware to non aware regions the sensor must go into the the non aware region by Threshmin + Hysteresiss or Threshmax - Hysteresis in order to become non aware. This prevents rapid reporting of data when the sensor is reading at or near a threshold. |
int? I3Hyst |
When going from aware to non aware regions the sensor must go into the the non aware region by Threshmin + Hysteresiss or Threshmax - Hysteresis in order to become non aware. This prevents rapid reporting of data when the sensor is reading at or near a threshold. |
int? V123ThreshMin |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? V123ThreshMax |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? I1ThreshMin |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? I1ThreshMax |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? I2ThreshMin |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? I2ThreshMax |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? I3ThreshMin |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
int? I3ThreshMax |
Values above ThreshMax or below ThreshMin will cause the sensor to go aware. |
double? MeasurementInterval |
Interval between measurements. |
Boolean? accumulate |
If set to accumulate the total power accumulation will add to the previous accumulation. If not set, total power accumulation will reset to 0 immediately after reporting. |
int? failedTransmissionsBeforeLinkMode |
The number of transmissions the sensor sends without response from a gateway before it goes to battery saving link mode. In link mode the sensor will scan for a new gateway and if not found will enter battery saving sleep mode for 2 hours before trying to scan again. Lower number will allow sensors to find new gateways with fewer missed readings. Higher numbers will cause the sensor to hold it setting in a noisy RF environment better. (Zero will cause the sensor to never enter link mode. to find a new gateway channel the battery will have to be cycled out of the sensor.) |
Copyright (c) 2023. All rights reserved.
|
What do you think about this topic? Send feedback!
|